Table of Contents
Advertisement
24 Introduction to the manual
Standard drive modules
• Install the additional components into the cabinet: for
example, main disconnector, main contactor, main AC
fuses, etc.
• Install the drive module into the cabinet.
• Connect the motor cables to the drive module terminals.
• Connect the DC connection cables (if any) to the drive
module terminals.
• If the main disconnector is installed into the cabinet,
connect it to the drive module terminals and the input
power cabling to the disconnector.
Drive modules with IP20 shrouds (option +B051)
Connect the external control cables to the drive control unit.
Check the installation.
Commission the drive.
Operate the drive: start, stop, speed control etc.
Task
See
Installing the drive module into a cabinet
93)
Connecting the power cables
Manuals for any optional equipment
Step-by-step drawings for an installation
example of drive module with options +B051
and +E208 in Rittal TS 8 600 mm wide cabinet
(page 175)
Connecting the control cables
Installation checklist
(page 97)
Start-up
(page 101)
Firmware manual
(page
(page
79)
(page 82)
Advertisement
Table of Contents
