Yamaha AG200FEB 2011 Owner's Manual page 68

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
3
2. Lift the wheel up between the fork
4
legs.
TIP
5
Make sure that the slot in the brake
shoe plate fits over the retainer on the
6
fork leg.
7
8
9
2
1
1. Brake shoe plate
2. Slot
3. Retainer
3. Insert the wheel axle from the right
hand side, and then install the axle
nut.
4. Lower the front wheel so that it is
on the ground.
5. Connect the brake cable at the
brake shoe plate and then at the
handlebar lever holder.
6. Connect the speedometer cable
and install the clip.
7. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
39 Nm (3.9 m·kgf, 28 ft·lbf)
7-33
8. Adjust the brake lever free play.
(See page 7-18.)
9. Slide the rubber cover back to its
3
original position.