Model 3830 S-Registers - Paradyne Comsphere 3830 User Manual

S0 Auto-Answer Ring Number
Determines the number of rings the modem will count before
automatically answering a call.
Enter zero (0) if you do not want the modem to automatically answer any
calls. Otherwise, enter a value from 1–255 for the number of rings to
count before answering. Note that if disabled, the modem can only
answer with an ATA command.
Factory setting is 1.
S2 AT Escape Character
Determines ASCII value used for escape sequence (+++) to enter
Command mode from Data mode.
Enter a value from 0 to 127 for the escape character. Any value greater
than 127 causes the modem to disable the escape sequence. When the
escape sequence is disabled, the modem cannot return to Command
mode until the call is disconnected.
Factory setting is 43 (ASCII + key).
S3 Carriage Return Character
Determines ASCII value used as the carriage return (Enter key). This
character is used to end command lines and result codes.
Enter a value from 0 to 127 for the command end character.
Factory setting is 13 (ASCII carriage return).
NOTE: The &W command used to save this change must be on a
separate line. This ensures both that the change is intentional, and that
the DTE can enter the new character.
S4 Line Feed Character
Determines ASCII value used as the line feed character.
Enter a value from 0–127 for the line feed character.
Factory setting is 10 (ASCII line feed).
3830-A2-GB91-20
Table 4-3
(1 of 15)

Model 3830 S-Registers

November 1996
4. AT Command Set and S-Registers
4-29