3810 Plus 4-Wire/2-Wire Leased-Line Network Connection - Paradyne COMSPHERE 3810Plus Installation Instructions

3810 Plus Dial-Line Connection
Use the following procedure to connect the 3810Plus
modem to the dial network interface:
1. Insert the 6-position, 4-conductor modular plug
into the jack labeled DIAL (Figure 2).
2. Insert the other end of the modular cord into the
dial network interface ("demarc").
8-POSITION
PLUG FOR
LEASED-LINE
NETWORK
OPERATION
6-POSITION PLUG
FOR PERMISSIVE
DIAL NETWORK
OPERATION
LEASED DIAL DTE 1
DB-25-P
CONNECTOR
FOR DATA
TERMINAL
EQUIPMENT
OPERATION
SUB-MINIATURE,
4-CONDUCTOR
PLUG FOR
NETWORK
MANAGEMENT
SYSTEM
OPERATION
Figure 2. 3810 Plus Rear Panel
3
3810 Plus 4-Wire/2-Wire
Leased-Line Network
Connection
Use the following procedure to connect a 3810Plus
modem to the leased-line network interface:
1. Insert the 8-position, 8-conductor modular plug
into the jack labeled LEASED (Figure 2).
2. Insert the other end of the modular cord into the
leased-line network interface ("demarc").
3. If you intend to use dial backup, follow steps
listed in 3810Plus Dial-Line Connection section.
NMS PWR ON OFF
POWER
SUPPLY
POWER
CORD