Paradyne COMSPHERE 3810 Firmware Update Manual page 7

Feature or
Configuration
Option
S36:
Rate Auto Originate
Table 1
(5 of 8)
New Features and Changes
Rate Auto Originate is a new configuration option. It is
available from the Leased Line group on modems with a
shared or integral Diagnostic Control Panel, and can be
set with the S36 command on all 3800 Series modems.
Its purpose is to initiate a dial backup call, using the
phone number in directory location 1, when the
leased-line rate of the modem falls back to or below a
certain speed. From the DCP, possible values for Rate
Auto Orig are:
Disable: The modem will not perform a Rate Auto
Originate.
OnFlBkTo48: If the leased-line rate of the modem falls
back to 4800 bps, a dial backup attempt
will be initiated.
OnFlBkTo72: If the leased-line rate of the modem falls
back to 7200 bps, a dial backup attempt
will be initiated.
OnFlBkTo96: If the leased-line rate of the modem falls
back to 9600 bps, a dial backup attempt
will be initiated.
OnFlBkTo120: If the leased-line rate of the modem falls
back to 12000 bps, a dial backup attempt
will be initiated.
OnFlBkTo144: If the leased-line rate of the modem falls
back to 14400 bps, a dial backup attempt
will be initiated. This is available only on
modems with the V.32 terbo feature.
OnFlBkTo168: If the leased-line rate of the modem falls
back to 16800 bps, a dial backup attempt
will be initiated. This is available only on
modems with the V.32 terbo feature.
6
Notes