Free Motion Darning, Embroidery And Monogramming; Preparation For Embroidering And Monogramming - Necchi C360 Instruction Manual

Free motion darning, embroidery and
monogramming
1 5
1
1
v Preparation for embroidering
and monogramming
* Embroidery hoop is not included with the
machine.
Using the darning/embroidery foot.
Move the drop feed lever to lower the feed
dogs.
①
Lowered position
Remove the presser foot holder and attach
the darning/embroidery foot. The lever should
be behind the needle clamp screw. Press the
darning/embroidery foot on firmly from behind
with your index finger and tighten the screw.
①
Lever
②
Needle clamp screw
③
Screw
Draw the desired lettering or design on the
surface of the fabric.
Stretch the fabric between the embroidery
hoop as firmly as possible.
Place the fabric under the needle. Make sure
the presser foot bar is down to its lowest
position.
Turn the handwheel towards you to bring up
the bobbin thread through the fabric. Sew a
few securing stitches at the starting point.
Hold the hoop with thumb and forefinger of
both hands while pressing the material with
the middle and third finger and supporting the
outside of the hoop with your small finger.
Keep fingers away from moving parts,
especially needles.
When you finish the work, move the drop
feed lever to raise the feed dogs.
Raised position
69
n Attention
Note