Free Motion Darning, Embroidery And Monogramming; Preparation For Embroidering And Monogramming - Necchi NC-204D Instruction Manual

Free motion darning, embroidery and
monogramming
1 5
3.5~5.0
1
v Preparation for embroidering
* Embroidery hoop is not included with the
Using the darning/embroidery foot.
Move the drop feed lever to lower the feed
dogs.
①
1
Remove the presser foot holder and attach
the darning/embroidery foot. The lever should
be behind the needle clamp screw. Press the
darning/embroidery foot on firmly from behind
with your index finger and tighten the screw.
①
②
③
Draw the desired lettering or design on the
surface of the fabric.
Stretch the fabric between the embroidery
hoop as firmly as possible.
Place the fabric under the needle. Make sure
the presser foot bar is down to its lowest
position.
Turn the handwheel towards you to bring up
the bobbin thread through the fabric. Sew a
few securing stitches at the starting point.
Hold the hoop with thumb and forefinger of
both hands while pressing the material with
the middle and third finger and supporting the
outside of the hoop with your small finger.
66
and monogramming
machine.
Lowered position
Lever
Needle clamp screw
Screw
n Attention
Keep fingers away from moving parts,
especially needles.
Note
When you finish the work, move the drop
feed lever to raise the feed dogs.
Raised position