Bar Tack Stitch - Necchi C360 Instruction Manual

Bar tack stitch

Bar tack stitch is used to reinforce points subject to strain, such as pocket corners and
openings.
023
1
Using the electronic buttonhole foot.
Extend the button holder plate and set to the
desire length. Adjust the stitch width and the
stitch length to the desired width and density.
①
Button holder plate
Attach the electronic buttonhole foot and plug
the cord into the socket above the presser
foot bar.
The upper thread should be passed through
the hole of electronic buttonhole foot and
bring the upper thread to the front of electronic
buttonhole foot.
Position the fabric so that the needle is 2mm
in front of where you want the sewing to start,
and then lower the presser foot lifter.
①
2mm
②
Starting point
Slightly hold the end of the upper thread and
start sewing.
2
Bar tack stitches are sewn.
It is suggested that you sew with a stabilizer
material under the fabric.
59
Note