Table of Contents
Advertisement
q
w
e
4
z x c v
q
e
r
w
START
STOP
t
w
y
u
Darning Stitch
q Stitch pattern:
w Thread tension dial: 3 to 6
e Presser foot:
• Starting to sew
z Pull the button holder q to the back.
x Place the garment under the foot. Press the needle
up/down button twice. Move the fabric to the left to
draw both threads under the foot.
c Lower the foot. Start the machine. The machine
will sew locking stitch, 16 rows of darning, locking
stitch again and stop automatically.
v Turn the fabric and repeat sewing in different
direction.
The machine will trim the threads at the end of
sewing automatically if the thread cutter sign is
indicated on the LCD display (see page 7).
q Button holder
w Starting point
e 3/4˝ (2 cm)
r 9/32˝ (0.7 cm)
NOTE:
The machine will cut the threads at the end of sewing
automatically if the thread cutter icon is indicated on
the LCD display (refer to page 20).
• Sewing a shorter darning
To sew a darning shorter than 3/4˝ (2 cm), first stop
the machine after sewing the required length y, then
press the reverse button t.
The required length y has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
t Reverse button
y Required length
u Starting point
• Sewing a same-sized darning
Simply start the machine to sew another darning at
the same size.
• Adjusting the evenness of the darning
Correct the evenness of the darning as follows:
Press the stitch length adjusting key to adjust the
evenness ("d5" is the default setting value).
When the right side of the darn is lower than the left
side, press "+" to set the value to "d6" to "d9", and
make the darn even.
When the left side of the darn is lower than the right
side, press "–" to set the value to "d1" to "d4", and
make the darn even.
37
17
Automatic buttonhole foot R
Advertisement
Table of Contents
