Terminal Port Options - Paradyne 7520 User Manual

Configuration Option Tables

Terminal Port Options

A-8
For Terminal Port options, refer to Table A-4. To access the Terminal Port Options
screen, follow this menu selection sequence:
Main Menu Configuration (Load Configuration From)
Configuration Edit/Display
Table A-4. Terminal Port Options (1 of 1)
Monitor DTR
Possible Settings: Enable, Disable
Default Setting: Enable
Specifies monitoring of the Data Terminal Ready (DTR) control lead.
Enable – Standard operation of the DTR control lead.
Disable – DTR is ignored. Some external device connections may require this setting.
Inactivity Timeout
Possible Settings: Enable, Disable
Default Setting: Disable
Provides automatic logoff of an ATI session through the Terminal Port. When the
session is closed, User Interface Idle appears on the screen and the unit toggles the
Terminal port DSR lead.
Enable – The ATI session terminates automatically after the Disconnect Time set in the
next option. When the session was occurring over an external modem connected to the
Terminal port, the modem will interpret the DSR toggle as DTR being dropped and
disconnect.
Disable – An ATI session through the Terminal port will remain active indefinitely.
Disconnect Time(minutes)
Possible Settings: range 1 – 60
Default Setting: 5
Number of minutes of inactivity before the ATI session terminates automatically.
Timeout is based on no keyboard activity.
Disconnect Time(minutes) option appears when Inactivity Timeout is enabled.
1 to 60 – The ATI user session is closed after the selected number of minutes.
Terminal Port
May 1998 7520-A2-GB20-20