Paradyne 7520 User Manual page 53

7520-A2-GB20-20
Table A-1. System Options (2 of 2)
Test Timeout
Possible Settings: Enable, Disable
Default Setting: Disable
Allows user-initiated tests to end automatically.
Enable – User-initiated loopback and pattern tests end when test duration is reached.
Disable – Tests must be terminated manually from the Network Tests screen. Refer to
Running Network Tests
in Chapter 5.
NOTE: Tests commanded by the DTE or network-initiated tests are not affected by
this test timeout.
Test Duration (min)
Possible Settings: 1–120
Default Setting: 10
Determines the number of minutes for a test to be active before automatically ending.
Test Duration (min) option appears when Test Timeout is enabled.
1 to 120 – Amount of time in minutes for a user-initiated test to run before terminating.
May 1998
Configuration Option Tables
A-3