Paradyne 7520 User Manual page 48

Messages and Troubleshooting
6-2
Table 6-1. Device Messages (2 of 2)
Device Message What Message Indicates
Invalid Test A loopback or 511 pattern
Combination test was in progress when
Start was selected to start
another test, or was active
on the same or another
interface when Start was
selected.
Please Wait Command takes longer
than 5 seconds.
Test Active A test is running and no
higher priority health and
status messages exist.
May 1998
What To Do
Wait until other test ends and
message clears.
Abort all tests from the Test
menu screen.
Stop the test from the same
screen the test was started
from.
Wait until message clears.
Contact service provider if test
initiated by the network.
Wait until the other test ends
and message clears.
Cancel all tests from the Test
screen.
Stop the test from the same
screen the test was started
from.
7520-A2-GB20-20