Table of Contents
Advertisement
Enable Command Failed • Link Test Function Canceled
Hardware El'l'Or on Receive
Cause: The line cannot be enabled.
Action:
•
Check that the IPL Port table has been correctly defined.
•
Check that the modem cable is correctly connected.
•
Check that the modem is powered up and operational.
•
If the link is a Direct Attachment, check that the responder is powered on and
initialized.
•
If the error persists after the above operations, contact the service
representative.
Note: The SCP, LCS, and SES are also displayed for this type of error.
Cause: A cable or modem error occurred on receive.
Action:
1. Verify the modem and modem cable.
2. Restart the test.
3. If the error persists, contact the service representative.
Notes:
1. The SCP, LCS, and SES are also displayed for this type of error.
2. Some errors of this type may disable the link. In this case, the PFl key is not
."'-._
./
made available and the following message is displayed in the message area:
/~.
LINK DISABLED - LINK TEST FUNCTION CANCELED.
3-2
3725 Communication Controller Stand-Alone Link Tests
Advertisement
Table of Contents
