Installing Your Interface Module(S) - Zhone 4000E Installation Instructions Manual

Installing Your Interface Module(s)

IPD4-A2-ZZ40-20
3 Slide the Management Module Firmly into the Chassis. Tighten the
fastening screws on the management module faceplate.
Interface modules provide the subscriber connections for a 4000E BLC; up to
four interface modules may be installed in the 4000E (in slots 1–4). There are
a variety of models available. Contact your sales representative. Any
combination of interface module models may be installed in an 4000E as long
as they are supported by the model type and version number of your
management module; refer to the Release Notes for your particular
management module model.
CAUTION
If a slot cover is removed from slots 2–4, it must be replaced with an
uplink module. DO NOT OPERATE A 4000E WITH AN EMPTY
MODULE SLOT.
1 Select a Slot for Installation.
Although the 4000E is factory shipped with Slot 1 open, interface
modules may be installed in any slot, 1–4.
4000E IP Broadband Loop Carrier Installation Instructions
Installing Your Interface Module(s)
9