Powering Up Your 4000E Blc - Zhone 4000E Installation Instructions Manual

Powering Up Your 4000E BLC

10
4000E IP Broadband Loop Carrier Installation Instructions
2 Align the interface module with the slot module guides. With the interface
module PCB facing up and the interface module model name on the right
side of the module faceplate (facing towards you), align the left and right
edges of the PCB with the slot module guides of the chosen slot on the
4000E.
3 Slide the interface module fFirmly into the chassis. Tighten the fastening
screws on the interface module faceplate.
CAUTION:
Turn your DC power source(s) OFF until you have completed connection
of the 4000E as outlined in the following sections.
Do not operate the 4000E without a ground connection.
1 Connect a ground wire to the 4000E: Line up the 2-hole terminal lug of
your ground wire with the two holes on the small, unpainted section on
IPD4-A2-ZZ40-20