Paradyne 3151 Features page 3

New General Management Configuration Options
SNMP Mgt: Disab
Next Enab Disab
SNMP Management Enable. Specifies whether the unit responds to SNMP session requests.
Enab – The unit responds to SNMP session requests.
Disab – The unit does not respond to SNMP session requests.
NMS Valid: Disab
Next Enab Disab
NMS IP Validation. Specifies whether the unit validates (for security reasons) the IP address of an SNMP manager
attempting to access the unit. Allowable addresses are specified using the NMS n IP Adr configuration option.
Enab – The unit validates the IP address of SNMP management systems attempting to access the unit.
Disab – The unit does not validate the IP address of SNMP management systems.
Num Sec Mgrs: 1
Next 1 2 3 4
Number of Security Managers. Specifies the number of SNMP managers that are allowed to access the unit.
NOTE: You must configure an IP address for each SNMP manager that is allowed access to the unit. Allowable
addresses are specified using the NMS n IP Adr configuration option.
NMS n IP Adr:
Next Edit Clear Prev
NMS Manager n IP Address. Specifies the allowable IP address of an SNMP manager attempting to access the
unit. The manager number ( n ) is specified by the Num Sec Mgrs configuration option.
Edit – Allows you to edit and/or display the allowable IP address for the SNMP manager.
Clear – Allows you to clear the allowable IP address for the SNMP manager. The IP address is set to
000.000.000.000.
NMS n Access: Read
Next Read R/W Prev
NMS Manager n Access Type. Specifies the allowable type of access for an SNMP manager attempting to access
the unit's MIB using community name 1.The manager number ( n ) is specified by the Num Sec Mgrs configuration
option.
Read – Allows read-only access (SNMP Get) to the accessible objects in the MIB for this device when community
name 1 is used. This includes all objects specified as either read-only or read/write in the MIB RFCs.
R/W – Allows read and write access (SNMP Get and Set) to the objects in the MIB for this device when community
name 1 is used. Write access is allowed for all objects specified as read/write in the MIB RFCs. Read access is
allowed for all objects specified as either read-only or read/write.
Prev
Prev
5 6 7 8 9 10 Prev
3