Paradyne 3151 Features page 2

New User Interface Configuration Options, continued
TnInActTm: Disab
Next Enab Disab
Telnet Inactivity Timeout. Specifies whether the Telnet session disconnects after a period of inactivity specified by
the TnDiscTm configuration option.
Enab – The Telnet session disconnects after the period of inactivity specified by the TnDiscTm configuration option.
Disab – The Telnet session does not disconnect due to inactivity.
TnDiscTm: 5
Next Up Down Save
Telnet Disconnect Time. Specifies the period of time (1 to 60 minutes) before the Telnet session disconnects due to
inactivity when TnInActTm is enabled. Use the left or right arrow key to position the cursor on the digit you want to
change. Use the Function keys (Up or Down) to increment or decrement the digit.
Up – Increments the time delay.
Down – Decrements the time delay.
Save – Stores the time delay for use with inactivity disconnects.
New Alarm Configuration Option
Trap Disc: Enab
Next Enab Disab
SNMP Trap Disconnect. Specifies whether the modem connection or carrier external communication port device
connection is disconnected after sending a trap message. This configuration option applies only to modem
connections or carrier external communication port device connections initiated as a result of the trap message
being sent.
Enab – Specifies that the modem call or carrier external communication port device call is disconnected after a trap
message is sent.
Disab – Specifies that the modem call or carrier external communication port device call is not disconnected after a
trap message is sent. The line is held until it is manually disconnected or disconnected by the remote modem.
NOTE: This configuration option is only available if SNMP traps are enabled and the integral modem or the carrier
external communication port device is enabled and configured as an SNMP management link.
Prev
Prev
Prev
2