Advertisement
e
Then press the AUTO TAKE Button (61) repeatedly. Two
versions adding different digital effects instantly can be
switched.
"Paint + Strobe
~~ Negative
Mosaic-Spotlight
e
To reset the functions to the factory set mode, press
the POWER
Button (1) off. Then while holding down
both color-A (49) and B (50) Buttons, press POWER
Button (1).
e
Select the same source input for both the A-bus and
B-bus.
e
The A-bus should have no Digital Effects applied to it
by pressing A-Button (A).
Turn the Mix/Wipe Lever (58) to the B-bus position.
Press the B-Button (22) on the DIGITAL EFFECT block.
Press the MOSAIC Button (24).
Press the Square Button (13) on the WIPE PATTERN
block.
e
Adjust the Mix/Wipe Lever (58) to obtain the desired
wipe size.
Press the Positioner ON/OFF Button (45).
e
The Positioner Joystick (46) now controls the location
of the mosaic image.
è
lf the border is desired to highlight the "anonymous"
area, press the EDGE Button (16) on the WIPE PATTERN
block.
e
If the Reverse function (REVERSE Button (12)) and/or
the Monochrome function (MONO Button (32)) is added,
more highlight effect can be produced.
Bus A
Bus B
OT
After Image
To reset the functions to the factory set mode, press
the POWER
Button (1) off. Then while holding down
both color-A (49) and B (50) Buttons, press POWER
Button (1).
Select the same source input for both the A-bus and
B-bus.
Press the STROBE Button (27).
Press the MIX Button (52).
Adjust the TIME Control (26) and Mix/Wipe Lever (58)
to obtain the necessary After Image.
If required,
press
the A/V Synchro
Control
(29) to
synchronize this effect to the audio.
Advertisement
