Advertisement
OFF
Gradation 1
Gradation 2
Note:
When
a Matte Color is selected
by the Source
Selector, it can be used as an alternate source
signal
for the
WIPE
(51),
MIX
(52) functions.
However,
Matte
Color
cannot
be used
in the
following effect operations.
In these cases, the
Source Video Signal indicated by a blinking source
button will be displayed instead of the Matte Color
on the monitor automatically.
1. LUM KEY (53) effect
2. DOWN STREAM KEY effect
3. (FADE CONTROL effect)
B-3. Audio Mixer
The
WJ-MX30
has
4 audio
source
inputs;
the
Source 1/2, an auxiliary audio input and the external
microphone.
Each
audio
level
can
be
adjusted
'ndependently by the audio faders.
1 ِ
The Source 1 Fader (70) adjusts the audio level of the
Source 1 Audio Signal; the Source 2 Fader (71) adjusts
that of the Source 2. The AUX Fader (72) or the MIC
Fader (73) adjusts each respective audio input signal
accordingly.
~45-
B-4. Color Correction
This function allows color adjustment from a selected
input source, as well as compensation for excessive
color.
Using the monochrome effect, a signal tint can
be imposed over on the entire scene image.
Notes:
1. Color Correction will have no effect if the selected
source video is a Black/White signal.
2. The MONO Button (32) for DIGITAL EFFECT should
be off.
3. The same color correction should be made on both
the A-bus and B-bus signals.
Press the Color Correction On/Off Button (48) on.
To correct the A-bus signal, press the A Button (49)
once.
The LED starts blinking.
In this case only the
CHROMA Control (47) corrects the color of the A-bus
signal. If you press the A-Button (49) a second time, the
LED lights. The CHROMA Control (47) and the R/G/B
Control joystick (46) are then valid for color correction
of the A-bus signal.
To make the color correction
function invalid, press the A Button (49) a third time to
turn off the LED.
To correct the B-bus signal, press the B-Button (50)
once.
The LED starts blinking.
In this case only the
CHROMA Control (47) corrects the color of the B-bus
signal.
If you press the B-Button (50) a second time,
the LED lights.
The CHROMA Control (47) and the R/G/B Control (46)
are then valid for color correction of the B-bus signal.
To make the color correction invalid, press the B-Button
(50) a third time to turn off the LED.
Advertisement
