Dometic FreshJet 7 Lite 48 V Series Installation Manual page 5

CAUTION! Failure to obey these cautions could result in minor or moderate injury.
• Only operate the appliance if you are certain that the housing and the cables are not damaged.
• Do not use the appliance near flammable fluids or in closed rooms.
• Ensure that no combustible objects are stored or installed near the air outlet. A distance of at least
50 cm must be kept.
• Do not reach into air outlets or insert any foreign objects in the appliance.
• Always wear protective goggles and gloves.
NOTICE! Damage hazard
• The appliance shall be stored so as to prevent mechanical damage from occurring.
• Before installation, check whether any vehicle components could be damaged by the installation of
the appliance (such as lamps, cupboards, doors). The vehicle manufacturer may have already pro-
vided points where the opening for the installation of the appliance can be made without any risk of
weakening the construction or cutting power cables.
• Before installation, consult the vehicle manufacturer whether the construction is designed for the
static weight and the loads of the roof air conditioner when the vehicle is in motion.
• Ensure the roof frame is sealed appropriately to the roof.
• Select a flat and sufficiently level area at the center of the vehicle roof between two longitudinal sec-
tions for installation.
• The roof inclination of the installation surface may not exceed 10 °.
• Ensure that there are no objects within the vehicle which could obstruct the attachment of the air
distribution box or the cooled air from flowing through the swivelling air distribution nozzles.
• Do not make any alterations or conversions to the appliance.
• Never drive through automatic car washes when the appliance is mounted.
• If faults occur in the refrigerant circuit, the system must be checked by a specialist company and re-
paired properly.
• The refrigerant must not be released into the air.
• Ask the vehicle manufacturer if the height entered in your vehicle documents needs to be altered
due to the installation of the roof air conditioner.
• When breaking into the refrigerant circuit to make repairs or for any other purpose eg. Remove re-
frigerant or open the circuit by cutting or brazing, follow the working procedure as indicated in ser-
vice manual.
• If charging refrigerant is needed, follow the charging procedure as indicated in service manual.
• When removing the refrigerant from system, follow the recovery procedure as indicated in service
manual.
Dometic FreshJet 7 Series Lite 48 V EN
5