Table of Contents
Advertisement
Problem
Probable cau8e(s)
Suggested remedy
While using the tape decks
Sound Is low, intermittent, of
Heads are dirty.
Clean the heads.
poor quality, noisy,
scratchy, or unsteady.
The Dolby NR switch is set in the wrong position.
Set it to match the recording condition.
The deck does not enter the
recording mode.
The erase-prevention t^ have been removed.
Attach tape to cover the space left by removal of the
erase-prevention tabs.
While listening to a c compact disc
The tray does not close
when a disc Is loaded and
the OPEN/CLOSE button
praasad.
The disc is not sitting correctly in the disc tray.
Re-insert the tray.
The total number of tracks
The disc is loaded upside down.
Re-load the disc.
and total time are not
The disc is dirty.
Wipe the disc with a soft cloth.
loaded.
The disc is scratched.
Replace the disc with a new one.
The disc does not start
The disc is badly warped.
button is pressed.
The disc used is a non-standard one.
Replace the disc with a different one.
There is condensation inside the CD player.
Switch ON the power, then wait for 20 to 30 minutes
before using it.
A certain part of the disc
The disc is dirty.
Clean the disc with a soft cloth.
cannot be played.
The disc is scratched.
Skip the scratched part of die disc (skip play).
While using the remt 3te controller
The system cannot be
operated with the remote
controller.
The batteries are inserted in the reverse polarity.
Re-insert the batteries in the correct polarity.
The dry batteries are worn.
Replace the batteries with new ones.
About moisture (for SLIGHT)
Moisture may form on the lens in the following
cases...
•Immediately after a heater has been turned on.
•In a steamy or very humid room.
•When the unit is suddenly moved from a cold environment to a
warm one.
If moisture forms inside this unit, it may not operate properly. To
correct this problem, turn on the power and wait about one hour for
the moisture to evaporate.
About cooling fan on the amplifier rear
panel
The cooling fan alternately rotates and stops in order to remove
heat from the amplifier. (Do not block off the outlet of the cooling
fan.)
Cooling fan
Amplifier
Advertisement
Table of Contents
