Table of Contents
Advertisement
Tape to Tape Recording
i
□
J
To record from deck 1 to deck 2
The recording level of the original (playback) tape, and the
noise-reduction effect on the original tape, will be recorded to the
new tape just as they were in the original recording.
Carry out the steps 1 and 2 of "Recording" on page 40,
1
Insert the blank tape Into deck 2 and the
pre-recorded tape into deck 1.
Be sure to load the tape in decks 1 and 2 with the forward side
uppermost (so that the "PLAY ►" indicator light).
2
Select the desired reverse mode.
: Single sided recording (forward side only)
: Two-sided recording
(forward side reverse side)
In case the length of a tape set in the deck 2 is longer
than a tape in the deck 1 tne deck 1 repeats the
playback until the deck 2 complete the two-sided
recording, (up to eight times)
• Tvw) sided recording
(forward side reverse side)
3
Press the edit speed button to select the
recording speed "xl" or "x2".
xl: Normal speed
x2: High spe^
4
Press the synchro-start button to start edlt-
recording.
The tape edit indicator on the cassette deck will illuminate.
When edit-recording is completed, the cassette deck automatically
creates a non-recorded passage of about four second in length,
and then enters the recording standby mode.
Note:
Be sure to press the edit speed button to go out of the edit speed
indicator after finishing recording.
■ To stop edIt-recordIng
I
g
I
Press the stop button.
If the ded( 1 operating indicator is lit, press the deck 1/ ded( 2
selector to select deck 2 before stop recording.
If you press the stop button while the deck 1 indicator is lit, the
cassette deck automatically creates a non-recorded passage of
about four seconds in length, and then enters the recording
standby state. Pressing the synchro-start button can resume
edit-recording.
■ To change the direction of tape travel
1) Press the one of the desired play button.
2) Press the stop button.
■ While edIt-recordIng Is taking place
You can press one of the input selector buttons on the amplifier
and enjoy listening to another music source, such as a CD.
You can chcmge the settings of the volume and tone controls of the
amplifier vnthout affecting the recording.
Note:
Switch off your television set or video equipment when performing
edit-recording at high speed (x2). The reason for this is that noise
Is sometimes picked up and recorded.
-46-
Advertisement
Table of Contents
