Advertisement
A Place firebox on cart. Attach with #10-24x3/4" machine screws, fiber washers and #10-24 wing nuts.
9
B Place burner assembly into firebox. Make sure venturi tubes and valves are correctly engaged. If burner is not leveled from
left to right, adjust the two screws attaching valve to control panel in Step 8. Attach burner assembly to firebox with fiber
washers and #8 sheet metal screws.
C Insert #10-24x1-1/4" screws into each side of firebox as shown. Inside firebox attach fiber washers and flanged nuts to
screws.
D Push control knobs onto valve stems.
E Connect ignitor wire to electrode terminal on burner.
Qty.4
#10-24
Qty: 4
Wing Nut
#10-24x3/4"
Machine Screw
A
10
Attach heat shield to left firebox support brace using #8 sheet metal screws.
10
Heat Shield
Qty: 2
#8 Sheet Metal Screw
Qty: 4
#10-24x1-1/4"
Machine Screw
Qty: 14
Fiber Washer
Firebox
D
Qty: 4
#10-24
Flange Nut
E
Ignitor Wire
Warning: Make sure heat shield is placed above the
two venturis, or else it drops down and may fail to
protect tank from being overheated.
Fiber Washer
B
#8 Sheet Metal Screw
Correctly assembled
valve in
Qty: 2
#8 Sheet Metal Screw
Heat Shield
C
burner tube
463731208 • 17
Advertisement
