Advertisement
Place control panel next to the front leg, put #10-24x2" machines screws through legs and control panel on both sides. Slide
7
the firebox support brace onto the machine screws and attach with #10-24 wing nuts. Attach firebox support brace to back legs
with #10-24x2" machine screws and #10-24 wing nuts.
Firebox
Support
Brace
Place valve/hose/regulator onto control panel. Attach with two #10-24x1/2" machine screws. (Note: Make sure the two valve
8
stems are leveled; otherwise, this can cause main burner level problems.) Insert ignitor into control panel. Connect round
terminal of the ignitor wire to pin located at the end of ignitor.
16 • 463731208
Back of cart
Valve/Hose/Regulator
Control Panel
Angled End
Straight End
Ignitor
#10-24
Wing Nut
Qty. 8
Qty: 8
#10-24x2"
Machine Screw
Qty: 2
#10-24x1/2"
Machine Screw
Advertisement
