Auto Find: Automatic Brand Code Search; Cleaning The Trackball - Zenith Presentation PRO900X Operating Manual

TRK4000PT TRACKBALL REMOTE CONTROL
AutoFind: Automatically searches all possible brand programming codes
1. Turn on the device you want to operate.
2. Press and hold the MUTE and FLSHBK keys until the
indicator light turns on.
3. Press MODE Left/Right until the indicator lights
underneath the device you're trying to program; TV,
VCR, Cable Box, Aux 1, Aux 2).
4. With the NUMBER keypad, enter the code 0-0-0
(zero-zero-zero), then press ENTER right away.
5. Aim the remote at the correct device and press
POWER. Allow a second to pass, then press POWER
again. Repeat until the device turns off.
6. Press ENTER to save the code. The indicator light
will blink three times and then turn off.
7. Press POWER to turn the device back on.
Notes:
• You can get out of AutoFind quickly by pressing QUIT. To
erase all the codes and return to factory preset codes, press
9-1-1 in Step 4 when programming the remote.
• If the indicator light does not turn off while you press
POWER, all the codes have been tried and your device can't be
programmed.

CLEANING THE TRACKBALL

To keep the remote functioning properly, it is necessary to
occasionally clean the trackball. To do this:
1. Use a solution of mild dishwashing detergent and
water.
2. Moisten a clean soft cloth with the solution and lay
the cloth flat on a table.
P A G E 2 0
3
4
rew
3. Turn the Z-Trak remote upside down and gently roll the
trackball on the cloth.
4. Allow the remote to air-dry before using it again.
Caution:
Do not use alcohol or other cleaning fluids to clean
the trackball as these may damage the remote.
5/7
cable
mode
2
surf
2
5
8
4/6
0
pip
play
ffwd
stop
206-3275-A