Trk4000 Trackball Remote Control; Introduction; Battery Installation; Programming Your Remote To Operate Other Ir Devices - Zenith Presentation PRO900X Operating Manual

TRK4000PT TRACKBALL REMOTE CONTROL

INTRODUCTION

This multi-brand remote operates the common features of most, but not all, models and brands of infrared controlled prod-
ucts. If some functions of your particular product cannot be controlled by this remote, use the original remote.

BATTERY INSTALLATION

Batteries are provided, but must be installed before using the
remote control. When the remote no longer functions normally,
or if it loses memory, replace the batteries with three high-
quality, alkaline, size AAA batteries. Match positive with posi-
tive (+ with +), and negative with negative (- with -) as
shown inside the battery compartment.
Notes:
• Do not place heavy objects on top of the remote keys; prolonged
unintentional remote operation shortens battery life.
• Remove the batteries if the remote will not be used for a month or
more. Battery leakage can permanently damage the remote, for which
Zenith is not responsible.
PROGRAMMING YOUR REMOTE TO OPERATE OTHER IR (Infra-red) DEVICES
1. Select the device you want to operate, then refer to pages
16/17 to find the programming brand code appropriate for
the type and brand of equipment. Make sure the device is
turned on.
2. Point the MBR Trakball remote control at the device you're
programming, and press MUTE and FLSHBK at the same
time. Hold until one of the mode indicator LEDs lights.
3. Use the MODE Right/Left key and select the mode you want
the device controlled in.
4. With the NUMBER Keypad, enter the three-digit code you
found in Step 1, press ENTER. If the code is accepted, the
mode indicator LED will blink three times. If it is not
accepted, the LED will not blink.
5. Press POWER to turn the device off. If nothing happens,
repeat the process from Step 1, and try the next brand code
number.
Notes:
• The TV and VCR modes will only accept codes for those types of
products. The AUX 1, AUX 2, and Cable modes will accept codes for
any kind of IR controlled product.
•
To get out of Programming before you enter a code, just press
QUIT on your remote.
P A G E 1 4
cable
3
mode
surf
2
4
5
8
0
pip
play
rew
stop
back of remote
5
2
4
ffwd
206-3275-A