Standard Connections; Connections Center; Connections Options; Connections Center Input And Controls Description/Function - Zenith Presentation PRO900X Operating Manual

CONNECTIONS CENTER

You have a choice of these video source connections: Video
In; S-Video In; and RGB with H/V Sync and V Sync. Use the
COMM jack to connect a computer serial port.

CONNECTIONS CENTER INPUT AND CONTROLS DESCRIPTION/FUNCTION

1. Remote Control Window — Receives the infrared signal
sent by the remote.
Note: Another remote control signal receiving window is
located on the front of the HD Display.
2. Up/Down/Left/Right arrows — Chooses on-screen menu
options.
3. ENTER — Use when an enter function is required.
4. MENU — Accesses on-screen menus.
5. POWER — Turns HD Display On and Off.
6. Power On Indicator — Lights when power is On.
7. R,G,B, H/V SYNC, V SYNC — Connect a video source that
provides video signals in the form of Red, Green, Blue,
Horizontal, Vertical Sync Outputs, to these input jacks.
3275-A

STANDARD CONNECTIONS

CONNECTIONS OPTIONS

You can connect equipment such as a: laser disc player,
VCR, computer, satellite receiver, or camcorder, (most
equipment that provides a video output)
8. Video In Jack — Connect a video source with a
9. Loop Out Jack — Provides the same VIDEO IN signal to
10.Loop Out/In Switch — Should be in the "In" position
11. S-Video — Connect a video source with an S-Video jack
12. COMM — Connect a computer or serial device to this
composite video output to this jack.
another component.
Note: Set Loop Out/In switch to "Out" if you connect a
video source to the Loop Out jack.
unless a video source is connected to the Loop Out jack.
Note: Failure to set switch to proper position could
result in a video overload or a washed out video.
(Y- C Connector) to this input jack.
jack.
.
P A G E 7