Barco FLM HD14 User Manual page 177

Error Description
code
5097 Flash
management
full
5096 Storing
unsuccessful
5095 Restoring
unsuccessful
6099
6098
7698 Light pipe
temp high
7697 Light pipe
temp open
7696 Light pipe
temp short
7695 Red front
DMD temp low
7694
Red front
DMD temp
high
7693 Red front
DMD temp
open
7692 Red front
DMD temp
short
7691
Green front
DMD temp low
7690 Green front
DMD temp
high
7689 Green front
DMD temp
open
7888
Green front
DMD temp
short
7687 Blue front
DMD temp low
7686 Blue front
DMD temp
high
7685
Blue front
DMD temp
open
R59770017 FLM HD14 26/09/2006
Error Warn- Caused by
ing
-
Yes Internal Backup device has
reached its maximum capacity
-
Yes Storing the custom settings into
internal backup device has failed
-
Yes Restoring the custom settings from
internal backup device has failed
Yes Yes High temperature on light pipe
entry
Yes Yes Temperature sensor on light pipe
not connected
Yes Yes Temperature sensor on light pipe
shorted
No Yes Low temperature on red DMD
Yes Yes High temperature on red DMD
Yes Yes Temperature sensor on Red DMD
not connected
Yes Yes Temperature sensor on Red DMD
shorted
No Yes Low temperature on green DMD
Yes Yes High temperature on green DMD
Yes Yes Temperature sensor on green
DMD not connected
Yes Yes Temperature sensor on green
DMD shorted
-
Yes Low temperature on blue DMD
Yes Yes High temperature on blue DMD
Yes Yes Temperature sensor on blue DMD
not connected
C. Troubleshooting
Action
Call a qualified service engineer
If problem persists, call a qualified
service engineer
If problem persists, call a qualified
service engineer
If problem persists, call a qualified
service engineer
Call a qualified service engineer
Call a qualified service engineer
Switching on the lamp will heat up
the DMD
Check if air slots are free.
Clean air filters.
If problem persists, call a qualified
service engineer
Call a qualified service engineer
Call a qualified service engineer
Switching on the lamp will heat up
the DMD
Check if air slots are free.
Clean air filters.
If problem persists, call a qualified
service engineer
Call a qualified service engineer
Call a qualified service engineer
Switching on the lamp will heat up
the DMD
Check if air slots are free.
Clean air filters.
If problem persists, call a qualified
service engineer
Call a qualified service engineer
173