Table of Contents
Advertisement
3
ELECTRICAL SECTION
IMPORTANT: The appliance must be installed by a qualified technician according with
the current local regulations and in compliance with the manufacturer instructions.
Incorrect installation might cause harm and damage to people, animals or objects,
for which the manufacturer accepts no responsibility.
Connection to a good earth wiring system is absolutely essential.
The manufacturer accepts no responsibility for any inconvenience caused by
failure to comply with this rule.
Before carrying out any work on the electrical section of the appliance, it must be
disconnected from the mains.
DETAILS
•
Connection to the electric power supply must be carried out by a qualified technician
and following the appropriate safety regulations;
•
Before carrying out the connection to the power supply, the voltage rating of the appliance
(stamped on the appliance identification plate) must be checked for correspondence to
the available mains supply voltage, and the mains electric wiring should be capable of
handling the hob's power rating (also indicated on the identification plate);
•
If the hob is supplied without a power supply plug and therefore if you are not connecting
directly to the mains, a standardized plug suitable for the load must be fitted.
•
The power point must be connected to a suitable earth wiring, in conformity to current
safety regulations.
•
It is possible to connect the appliance directly to the mains supply by means of a heavy
duty switch with 3 mm minimum distance between the contacts.
•
The power supply cord must not touch against any hot surfaces and must be placed so
that its temperature does not exceed 50°C at any point along its length.
•
Once the appliance has been installed, the switch or socket must always be accessible.
•
The appliance must have its own supply; any other appliances installed near it must
be supplied separately.
–
N.B. For connections to the mains power supply, never use adapters, reductions
or multiple power points as these may overheat and catch fire.
If the hob surface is cracked disconnect the appliance from the mains and
–
contact the After-Sales Service.
In the event that installation should require modifications to the mains supply wiring system
or if the power plug is not suitable for the type of power point available, it is recommended
that a qualified technician be called to carry out substitution.
The technician will also have to verify that the cross-section of the electric cables on the
power point match the appliance's power rating.
19
19
Advertisement
Table of Contents
