Auto Programming: Finding/Erasing Channels - Zenith L20V26C Installation, Setup & Operating Manual

Auto Programming: Finding/Erasing Channels

- For Auto program to work, the programming source must be connected to the TV and the TV must be
receiving programming signals either over-the-air or from a cable-type service provider.
Channel Search (Auto Programming)
Channel Search (Auto Programming)
a.prog
1 Press the button on the remote
control.
Auto program
- When the channel search is complete, use the channel (
channels.
- If you press the
nels found and programmed up to that time will remain in memory.
- Auto programming function can memorize only the channels which are being received at that
time (some stations have limited broadcast hours).
206-3921
2
F G
enter ( A ) button during auto programming, the function will stop and only chan-
Press the a.prog or volume (
buttons to begin the channel search.
Wait for auto program to complete the
channel search cycle before choosing a
channel. The TV scans for over-the-air
channels and then channels provided by a
cable service.
Channel number being
memorized is displayed.
Auto program TV 63
34%
A
Stop :
D,E ) buttons to review the memorized
F , G )
23