Antenna/Cable Connections - Zenith L20V26C Installation, Setup & Operating Manual

Antenna/Cable Connections

- For optimum picture quality, adjust antenna direction.
Connecting to an Inside
Connecting to an Inside
Typical wall antenna jack used in apartment buildings, connect the antenna cable as shown below.
(Use the correct type of antenna cable for the type of wall antenna jack.)
Apartment Buildings Wall Connection Jack
- If you have a 75
nut. If you have a 300
then connect the converter to the antenna jack on the TV.
- When using 75
quality.
Connecting to an Outdoor
Connecting to an Outdoor
This type of antenna is commonly used in single family dwellings.
VHF Antenna
UHF
Antenna
Single Family Home
- In poor signal areas, to get better
picture quality, install the signal
amplifier as shown to the right.
- If antenna is split for two TVs, use a
signal splitter for connection.
14
Antenna Setup
Antenna Setup
Turn clockwise to
tighten.
75 Round Cable
Bronze Wire
300 Flat Wire
round cable, insert the bronze wire and then tighten the connection
flat wire, connect the twisted wire to the antenna converter and
round cable, do not bend the bronze wire. It may cause poor picture
Antenna Setup
Antenna Setup
Turn clockwise to
tighten.
75 Round Cable
300 Flat Wire
VHF
signal
Amplifier
VIDEO L AUDIO R ANT IN
LL
75
MONITOR OUT
Antenna
Converter
Antenna jack
VIDEO L R ANT IN
AUDIO
LL 75
MONITOR OUT
Bronze Wire
Antenna
Antenna jack
Converter
VIDEO L AUDIO R ANT IN
LL
UHF 75
MONITOR OUT
206-3921