Remote Control; Installing Batteries/ Operation - Zenith L20V26C Installation, Setup & Operating Manual

Remote Control: Installing Batteries/Operation
Installing Batteries
Installing Batteries
1 Pull the battery cover
upward in the direction
shown by the arrow
and remove it.
2 Insert the batteries
with correct polarity,
match "+" and "-".
3 Replace the battery
compartment cover.
- Install two AAA, 1.5V batteries. Don't mix used batteries with new batteries.
- Remove batteries when you won't use the remote control for a long time. Liquid leakage
from batteries may damage the remote.
Notes For Using Remote Control
Notes For Using Remote Control
Make sure there are no
objects between the
remote control and its sen-
sor.
10
Don't place the remote control
near a heater or in a damp
place. A strong impact on
remote control may damage it.
Remote
power tv/video
Control Sensor
1 2 3
4 5 6
7 8 9
apc cc
0
menu mute
ch
vol vol
enter
mts ch sleep
fcr flashbk dasp
a.prog memory/erase
IR Signals from the remote
control could be affected by
sunlight or other bright lights.
In In this case, darken the
room.
206-3921