Graco PRO-WASH 112636 Instructions-Parts List Manual page 4

FIRE AND EXPLOSION HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury.
D Ground the equipment. See Grounding on page 8.
D Provide fresh air ventilation to avoid the buildup of flammable fumes from the solvent.
D Extinguish all the open flames or pilot lights in the gun washer area.
D Electrically disconnect all the equipment in the gun washer area.
D Keep the gun washer area free of debris, including solvent, rags, and gasoline.
D Do not turn on or off any light switch in the gun washer area while operating or if fumes are
present.
D Do not smoke in the gun washer area.
D Do not operate a gasoline engine in the gun washer area.
D Follow the gun manufacturers solvent and other cleaning recommendations.
D Use solvent with the highest possible flash point.
D Use non-conductive solvent when cleaning electrostatic guns.
D Do not allow solvent to enter the air passage of an electrostatic gun.
D Do not flush an electrostatic gun with the electrostatics ON-OFF lever in the ON position.
D If there is any static sparking while using the equipment, stop operation immediately. Identify
and correct the problem.
D Drain the solvent into a proper storage container when the gun washer(s) is not in use.
TOXIC FLUID HAZARD
Hazardous fluids or toxic fumes can cause serious injury or death if splashed in the eyes or on the
skin, swallowed, or inhaled.
D Know the specific hazards of the fluid you are using. Read the fluid manufacturer 's warnings.
D Store hazardous fluid in an approved container. Dispose of hazardous fluid according to all local,
state and national guidelines.
D Wear the appropriate protective clothing, gloves, eyewear and respirator.
D Pipe and dispose of the exhaust air safely. If the diaphragm fails, the fluid may be exhausted along
with the air. See your separate pump instruction manual for further information.
4 308393
WARNING