Table of Contents
Advertisement
WARNING
TOXIC FLUID HAZARD
Hazardous fluids or toxic fumes can
cause serious injury or death if splashed
in the eyes or on the skin, swallowed, or
inhaled.
D Know the specific hazards of the fluid you are
using. Read the fluid manufacturer's warnings.
D Wear the appropriate protective clothing,
gloves, eyewear and respirator.
WARNING
FIRE AND EXPLOSION HAZARD
To avoid igniting flammable liquid solvent
vapors and reduce the risk of serious
injury, fire, or explosion:
D Keep all ignition sources, such as
static electricity, sparks, arcs, open
flames, and hot objects, away from
the gun washer.
D Cleanup solvent leaks or spills immediately. Re-
pair leaking components before operating the
gun washer again.
D Use solvent with the highest possible flashpoint.
D Follow tne FIRE AND EXPLOSION HAZARD
warnings on page 4.
CAUTION
Use only non-conductive solvents when cleaning
electrostatic guns. Conductive solvents can cause
the gun to malfunction.
Follow the gun manufacturers solvent and other
cleaning recommendations.
10
308393
Operation
Pressure Relief Procedure
PRESSURIZED EQUIPMENT HAZARD
The system pressure must be manually relieved to
prevent the system from starting accidentally. To
reduce the risk of an injury from accidental spray,
splashing fluid, or moving parts, follow the Pres-
sure Relief Procedure whenever you:
D are instructed to relieve the pressure,
D shut down the gun washer,
D check, clean, or service any of the system
equipment.
1. Disconnect the air supply.
2. Drain the solvent into a proper solvent container.
Place the container under the fluid drain valve on
the bottom of the tank and open the fluid drain
valve.
Filling the Gun Washer Fluid Tank
1. Make sure the fluid drain valve is in the closed
position. Fill the gun washer fluid tank with solvent
as instructed for your gun washer model, below.
2. Models 112634 and 112635: Carefully pour sol-
vent into the fluid tank until the fluid level is at least
1/2 inch (12.7 mm) above the filter in the lower
portion of the cabinet.
Model 112636: Carefully pour solvent into the fluid
tank until the fluid level is just below the bottom of
the manifold assembly.
NOTE: Do not pour more than 5 gallons (18.9 liters) of
a compatible solvent into the fluid tank.
WARNING
Advertisement
Table of Contents
