Table of Contents
Advertisement
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result
in serious injury.
INSTRUCTIONS
D This equipment is for professional use only.
D Read all instruction manuals, tags, and labels before operating the equipment.
D Use the equipment only for its intended purpose.
D Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D Check the equipment daily. Repair or replace worn or damaged parts immediately.
D Do not exceed the maximum working pressure of the lowest rated system component. This equip-
ment has a 100 psi (7 bar) maximum fluid working pressure at 100 psi (7 bar) maximum
incoming air pressure.
D Do not operate the gun washer at a pressure above the maximum working pressure rating of the
gun(s) being cleaned.
D Route the hoses away from the traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180_F (82_C) or below –40_F (–40_C).
D Do not use the hoses to pull the equipment.
D Do not move pressurized equipment.
D Use fluids or solvents that are compatible with the equipment wetted parts. See the Technical
Data section of all the equipment manuals. Read the fluid and solvent manufacturer 's warnings.
D Comply with all applicable local, state and national fire, electrical and other safety regulations.
PRESSURIZED EQUIPMENT HAZARD
Spray from hose leaks, ruptured components, or from operating the gun washer with an open lid can
splash fluid in the eyes or on the skin and cause serious injury.
D A safety device has been installed to shut off the pump when the gun washer lid is opened. Do not
tamper with or alter this device.
D Open the gun washer lid slowly.
D Do not prop the gun washer lid open with an object or by any other means.
D Do not stop or deflect fluid leaks with your hand, body, glove, or rag.
D Follow the Pressure Relief Procedure on page 10 whenever you: are instructed to relieve the
pressure; stop operating the gun washer; and clean, check, or service the equipment.
D Tighten all the fluid connections before operating the equipment.
D Check the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immediately.
Permanently coupled hoses cannot be repaired; replace the entire hose.
WARNING
308393
3
Advertisement
Table of Contents
