Tar River BWC Series Operator's Manual page 25

BWC Hydraulic Feed Wood Chipper
Assembly
Operating Instructions
Discharge Chute Adjustment
The Discharge Chute can be adjusted to direct the expelled material in a safe direction. Warning: Material
exists the Discharge Chute at a high rate of speed. Always keep people and animals out of the work area to
prevent serious injury or death.
To rotate the Discharge Chute, pull up on the Locking Handle and twist the Discharge Chute clock-wise or
counter-clockwise to the desired position. Release the Locking Handle and make sure the chute is locked in
place before operating the wood chipper.
Discharge Deflector Adjustment
The Deflector can easily be adjust to control the distance chips are discharged. Turn the handle counter-
clockwise, raise or lower the deflector in the desired position. Tighten the handle by turning it clockwise.
Note: It is not necessary to remove the handle, only loose enough to raise or lower the deflector.
25