Pto Instructions - Tar River BWC Series Operator's Manual

BWC Hydraulic Feed Wood Chipper
1. Begin by parking the tractor and implement on a level, solid surface. Attach the implement to the trac-
tor's hitch arms, upper and lower. Adjust the tractor's 3-point hitch so that the tractor's output shaft is
level with the implement's input shaft.
2. Leave the tractor in gear, shut off the tractor engine, remove the key and set the park brake. Block the
implement to prevent it from falling over or shifting.
3. Slide the inner yoke of the PTO shaft 'A' (implement end) onto the input shaft of the implement.
Make sure the yoke is securely locked in place.
4. Slide the outer yoke of the PTO shaft 'B' (tractor end) onto the tractor input shaft. Make sure the yoke
is securely locked in place.
5. Because of differences in tractor 3-point arms and implements, it may be necessary to shorten the PTO
Driveline. See next page for "
6. Check that the PTO Driveline yokes are securely attached to the tractor and implement before operat-
ing. PTO Drivelines not attached properly can cause serious injury or death!
7. If your PTO Driveline shields are equipped with chains, secure the chain to the tractor and or imple-
ment to prevent the shield from rotating.
8. Before starting tractor and engaging the PTO Driveline, make certain there are no people or animals
between tractor and implement. Rotating PTO Drivelines can cause serious injury or death!
PTO Driveline Instructions
Instructions for Installing a PTO Driveline:
Instructions for Shortening a PTO Driveline"
Danger: Always make sure shields are in
place before operating the implement/
tractor! Serious injury or death can occur!
Note: Some shields/parts are removed from
image for clarity only.
Inner Driveline
B
Outer Driveline
Tractor End
13
.
A
Implement End