Tar River BWC Series Operator's Manual page 14

BWC Hydraulic Feed Wood Chipper
Note: If you are not confident modifying the PTO Driveline, you should contact a Qualified
Professional.
 Separate the inner and outer PTO Drivelines. Leave separated at this time.
 Attach the outer PTO Driveline to the tractor implement input shaft and inner PTO driveline to the
implement input shaft.
 With the drivelines parallel to one another, measure 1" (dim. 'B') back from the outer PTO Driveline
shield (see fig. 2) and make a mark on the inner PTO Driveline.
 Measure 1" (dim 'B') back from the inner PTO Driveline shield (see fig. 2) and make a mark on the
outer PTO Driveline.
 Remove the drivelines from the tractor and implement.
 Measure from the end of the inner shield to the scribed mark (dim. "C"). Cut the inner shield at that
mark. Cut the same amount off the inner shaft (dim. "C1").
 Measure from the end of the outer shield to the scribed mark (dim. "D"). Cut the outer shield at that
mark. Cut the same amount off the inner shaft (dim. "D1").
 Clean off all burrs from both drivelines.
 Refer to "Checking PTO Driveline Extended Length" section next.
PTO Driveline Instructions
Instructions for Shortening a PTO Driveline:
14