Samsung 400T7A User Manual page 78

Adding the hard drive (HDD)
6
Remove power cables or signal cables connecting the current
hard drive.
Power cable latch
Power cable
The picture above shows the cable locations on a detached
hard drive case.
When disconnecting the power cable and signal cable, be
sure to push each latch to remove.
The connection ports may be damaged if this is not done.
7
Insert the new hard drive and secure it with four screws.
(for 400S7A/400S7B models only)
Signal cable latch
Signal cable
8
Connect the power cable and signal cable to the hard drive
and then install the hard drive case in the computer.
Connect this to the new hard drive.
Power cable
Signal cable Connect this to the existing hard drive.
Chapter 3.
78
Settings and Upgrade