Table of Contents
Advertisement
Operation
Automatic boost function
Power setting
1
2
3
4
5
6
7
8
9
Time (min:sec)
0:48
2:24
3:50
5:12
6:48
2:00
2:48
3:36
-
Automatic boost function
Parboiling takes place at power level 9 with the automatic boost function.
After a certain time the power level will switch down automatically to a lower
simmering setting (1 to 8).
When using the automatic boost function only the simmering setting with
which the food is to be cooked through needs to be selected since the elec-
tronic unit switches down automatically.
The automatic boost function is suitable for dishes which are cold initially and
are then heated up at high power. These dishes do not need to be constantly
monitored when simmering (e.g. boiling meat for soups).
1. Switch a cooking zone on. The stand-by dot of the cooking zone selected
must light up. It may be necessary to press a cooking zone selection
key (e.g.
for front left).
2. Select power setting 9. Pressing the Plus key
automatic boost function.
The power level setting will indicate A and 9 alternately.
3. Then immediately use the Minus key
setting from 1 to 8.
A and the selected simmering setting will blink alternately.
4. The automatic boost function will operate as programmed. After a certain
time (see chart) the cooking process will be continued with the simmering
setting.
Instructions
• While the automatic boost function is in operation, the Plus key
used to raise the simmering power setting. Pressing the Minus key
switch the automatic boost function off.
• If, after activating the automatic boost function, the power level is left at
level 9 and no lower simmering setting is selected, the automatic boost
function will be switched off automatically after 10 seconds and the cooking
level will remain at 9.
Switching on the second element
(only for cooking zones with several circuits)
Two-circuit connection of the respective cooking zone can only be effected
after the corresponding cooking zone has been switched on.
1. Select the desired cooking level 1-9.
2. Switch on the second heating circuit with the circuit activation key
The control lamp (dual circuit activation) will light up.
3. The outer heating circuit will be switched off when the circuit activation
key
is pressed again.
The control lamp will go off.
Note
The activated heating circuits will automatically be deselected when the cook-
ing zone is switched off.
GB
again will activate the
to select a lower simmering
can be
will
.
25
Advertisement
Table of Contents
