Page 1
Instructions for use and installation instructions Instructions d’utilisation et avis de montage Gebruiksaanwijzing en montagehandleiding Istruzioni di uso e di montaggio Instrucciones de uso y de montaje Instruções de uso e de montagem Ðtv³wuÒ xvÒvÒ ÊËw Ò´ÎËxÑÐÌгvÒvÒ EKE 605.2F / 905.2F...
What to do if you happen to have an old appliance Old appliances contain many materials which can be recycled. For this reason you should not simply put your old appliance on the rubbish tip, but ask your local authority how it might be recycled. EKE 605.2F / 905.2F...
All manuals and user guides at all-guides.com Your appliance at a glance EKE 605.2F 1 Triple-circuit cooking zone 2 Sensor buttons for cooking settings 3 Off-sensor EKE 905.2F 4 Stand-by sensor 5 Child proof lock (sensor-lock) 6 Frying zone EKE 605.2F / 905.2F...
– if no cooking zone is activated within 20 minutes (after 10 seconds an acustic signal indicates that the appliance switches itself off after another 10 seconds) – if the appliance is not used 1 minute after starting operation. EKE 605.2F / 905.2F...
Cooking zone heating indicator As long as the cooking zone is still hot, an “H” will appear in the dis- play when the cooking zone has been switched off. Press the plus- and minus-sensor at the same time. EKE 605.2F / 905.2F...
After not more than 3 seconds press the sensor under the flashing control indicator on the right. Note: When the power supply has been interrupted the child proof lock is no longer active. EKE 605.2F / 905.2F...
The rating plate is lo- cated underneath the cooking area. The rating label is located at the bottom side of the hob. It is also stuck onto the cover page of this operating manual. EKE 605.2F / 905.2F...
Apply the compound in a continuous strip, pressing it firmly against the gap to be sealed. – Cut away any surplus sealing compound with a sharp knife and clean the sealed joint with water. EKE 605.2F / 905.2F...
Page 9
– Put the hob into the worktop cut-out and align it. – Screw the hob to the assembly panel from the bottom. Minimum distance to adjacent walls Cut-out dimensions Exterior hob dimensions EKE 605.2F / 905.2F...
Page 10
When connecting the hob, a device must be provided which enables all- Total connection output: pole disconnection of the hob from the supply with a gap construction of at EKE 605.2F 6,7 kW least 3 mm. Circuit breakers, fuses and contactors are considered to be EKE 905.2F 9,2 kW suitable disconnecting units.
Need help?
Do you have a question about the EKE 605.2F and is the answer not in the manual?
Questions and answers