Cable Service - Zenith Concierge H19D34Y Installation And Operating Manual, Warranty

Cable Service Hook Up (CATV)
Connect cable service to the Concierge TV
1
Locate the Antenna/Cable jack on the back of the
Concierge TV.
2
Connect the cable service wire that runs from the wall,
according to one of the diagrams to the right.
3
Remove the back of the remote and put in two AA batter-
ies.
4
Plug in the TV. Do not plug it into a switched outlet. The
Concierge TV is designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to operate it on DC
power.
5
Go to page 11 to Auto Program the Concierge TV.
If you're using a cable box, leave the TV tuned to channel 3
or 4 and use the cable box to change channels.
If you're using a cable box, Auto Program might only find the
channel your cable service is on (usually channel 3 or 4).
Model H25D39Y is not equipped with an MPI card.
206-3490-O
back of
remote
Cable TV
Wall Jack
Super
RF Coaxial Wire Port
(75 ohm)
TV Back Panel
(Expanded View)
Cable TV
Wall Jack
Cable Box
In
output
Out
switch
3 4
Super
RF Coaxial Wire
(75ohm)
TV Back Connections Panel
(Expanded View)
TV Back
ANTENNA
CABLE
VIDEO SPEAKER
M.P.I.
IN OUT
AUDIO
IN
TV Back
Port
VIDEO SPEAKER
M.P.I.
OUT
IN
AUDIO
IN
P A G E 7