Setup Menu (Start With Page 11, Auto Program) Add/Del/Blank - Zenith Concierge H19D34Y Installation And Operating Manual, Warranty

Channel Add/Delete/Blank
Fine-tuning the guest's channel selection list
1
Press the MENU key on an Installer's remote so the SETUP MENU
appears.
2
Press SELECT repeatedly to go to the Add/Del/Blnk option.
3
Using either the NUMBER keypad and ENTER or the Channel
Up/Down arrows on the remote, select a channel. (If adding a
deleted channel, you will need to use the number keypad and
ENTER.)
4
Using the Right/Left ADJ arrows, pick whether that channel is
Added, Deleted, or Blank.
5
To continue, select another channel and repeat from Step 3.
When you are finished, press ENTER to remove menu.
Adding Aux, VCR 3, or VCR 4 to the Channel
Preview List
Go to the Setup menu, select the Add/Del/Blnk option. Use
Channel Up/Down to select the option and choose Added.
Note: If the option was turned off in the Service menu, you will
have to reinstate it before it can appear as an option in the
Channel Preview list.
Notes: Adding VCR 3 and/or VCR 4 as available channels forces
TV Channel 3 and/or 4 to be retained, when running Auto
Program (Channel Search), even though the equipment connect-
ed to the Antenna/Cable (RF) jack (like a cable converter and/or
VCR) may be turned off.
You can elect to Add, Delete or Blank: VCR 3, VCR 4, and Aux.
If you delete a channel, it isn't gone for good. Just select it
using the NUMBER keypad on the remote, or add it later.
Mini glossary
ADD Adds new channels to the list that the guest can scroll through when using the remote.
DELETE Removes channels for one reason or another from the list that the guest can scroll through.
BLANK Removes the video signal from a channel so the guest will only receive the audio signal
P A G E 1 6
CH 44 ADDED
1 2
4 5
3
7 8
0
ENTER
TIMER
MENU
SELECT CH PREVIEW
2
ADJ
4
.
3
3
6
9
3/5
1
ALARM
ADJ
206-3599-O