Cable Service - Zenith H27E46DT Installation And Operating Manual, Warranty

Hook Up Your Cable (CATV) to the TV
Connect cable service to the Presentation TV
1
Locate the Antenna/Cable jack on the
back of the Presentation TV.
2
Connect the cable that runs from the wall,
according to one of the diagrams to the
right.
3
Remove the back of the remote and put in
two AAA batteries.
Back of
Remote
4
Plug in the TV. The Presentation TV is
designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to
operate it on DC Current.
5
Go to page 21 to Auto Program the
Presentation TV.
If you're using a cable box, leave the TV on
channel 3 or 4 and use your cable box to
change channels.
If you're using a cable box, Auto Program might
only find the channel your cable service is on
(usually channel 3 or 4). Don't worry, that's all
you need!
P A G E 1 6
Cable TV
Wall Jack
COMPUTER
Round Wire
IN
(75 ohm)
Cable TV
Wall Jack
Cable Box
In
output
Out
switch 3 4
RF Coaxial Wire
(75ohm)
TV Back
ANTENNA
CABLE
S-VIDEO OUT
S-VIDEO IN
R- AUDIO- L
R- AUDIO- L
VIDEO
AUX IN
M.P.I.
R
AUDIO OUT
R- AUDIO- L
COMPUTER
L
AUDIO
TV Back
ANTENNA
CABLE
S-VIDEO OUT S-VIDEO IN
COMPUTER
IN
VIDEO
AUX IN
M.P.I.
R
AUDIO OUT
COMPUTER
L
AUDIO
R- AUDIO- L
R- AUDIO- L
R- AUDIO- L
206-4543