Antenna; Antenna Hook Up - Zenith Concierge H19D34Y Installation And Operating Manual, Warranty

Antenna Hook Up

Connect an over-the-air antenna to
the Concierge TV
1 Locate the Antenna/Cable jack on the back of the
Concierge TV.
2
Connect the antenna wire that runs from the wall,
according to one of the diagrams to the right.
3
Remove the back of the remote and put in two AA
batteries.
4
Plug in the TV. Do not plug it into a switched out-
let. The Entertainment Machine is designed to
operate on standard current, 120-volt 60 Hertz AC.
Do not attempt to operate it on DC power.
5
Go to page 11 to Auto Program the TV.
If you have a 75 ohm RF cable, then you don't need any
adapters!
A 300 to 75 ohm adapter is not included with the Zenith
Concierge TV.
Model H25D39Y does not have the MPI card.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
300 TO 75 OHM A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
P A G E 6
back of
remote

Antenna

Flat wire
(300 ohm)
Super
Port
TV Back Panel
300/75 ohm
(Expanded View)
Adapter
TV Back
Antenna
ANTENNA
CABLE
Super
Port
RF coaxial wire
M.P.I.
(75 ohm)
TV Back Panel
(Expanded View)
TV Back
ANTENNA
CABLE
VIDEO SPEAKER
M.P.I.
IN OUT
AUDIO
IN
VIDEO SPEAKER
IN OUT
AUDIO
IN
206-3490-O