Connecting Antenna - Zenith ZLD15A1 Operating Manual & Warranty

Connecting antenna

* To get better picture quality, adjust the direction of antenna.
Connecting to wall antenna socket
Connecting to wall antenna socket
● In case of wall antenna socket in apartment houses, connect the antenna cable as shown below.
( Use the correct type of antenna cable to the type of wall antenna socket.)
Apartments
* In case of 75Ω round cable, insert the bronze wire and then tighten the connecting nut.
And in case of 300Ω flat cable, connect the twisted wire to the antenna converter and
then connect the converter to the antenna input port.
* When using 75Ω round cable, do not bend bronze. It may cause poor picture quality.
Connecting to outdoor antenna
Connecting to outdoor antenna
●
This type of antenna is usually used at common private houses.
Private house
* In poor signal area, you can get better
picture quality if you install the anten-
na like the figure as shown right.
* If an antenna is divided to two TV
sets, use "signal divider" for connect-
ing.
14
75Ω round cable
300Ω flat cable
wall connecting port
VHF antenna
75Ω round cable
UHF
antenna
300Ω flat cable
VHF
Turn clock arise to
tighten.
bronze wire
DC 12V
antenna
converter
antenna input port
Turn clock arise to
tighten.
bronze wire
DC 12V
antenna
converter
antenna input port
UHF
signal
amplifier
ANT. IN COMPONENT INPUT
B
COMPONENT INPUT
ANT. IN
B
DC 12V
COMPONENT INPUT
ANT. IN
B
206-3652