Table of Contents
Advertisement
Hook Up an Off-Air Antenna
Connect an off-air antenna
1
Locate the Antenna/Cable 1 jack on the back
of your TV.
2
Connect the antenna wire that runs from the
wall directly to this jack, according to one of
the diagrams to the right.
3
Remove the back of the remote and put in two
"AAA" batteries.
Back of
Remote
4
Plug in your TV. Your TV is designed to operate
on standard household current, 120-volt 60
Hertz AC. Do not plug it into an outlet con-
trolled by a switch. Do not attempt to operate
it on DC power.
120 V AC
60 Hz
If you have a 75 ohm RF cable, then you don't need
any adapters!
A 300 to 75 ohm adapter is not included with the TV.
Mini glossary
75 OHM RF CABLE
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded antenna/cable jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
300 TO 75 OHM
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
P A G E 8
Antenna
Flat Wire
(300 ohm)
300/75 ohm
Adapter
Antenna
RF Coaxial Wire
(75ohm)
Typical
TV Back
Typical
TV Back
206-3767
Advertisement
Table of Contents
