Table of Contents
Advertisement
Verify 3-Digit Code Stored in Mode
Use the following method described below to find the code number stored in
memory for each remote operating mode: TV, VCR, CABLE, and AUX
1
With a small blunt object, press and hold PRG for about three
seconds. When the light turns on, release PRG.
2
Press the mode button you want the 3-number code for, then
press the TIMER button.
The LED will blink the number of times to indicate the num-
ber of the first digit. There will be a 1 second pause during
which the LED light will be off, then the LED will blink the
number of times for the second digit of the code, and so on.
For example:
- One blink, no LED light for 1 second.
- Three blinks, no LED light for 1 second.
- Eight blinks.
This is the example for code: 1-3-8.
Note: Ten blinks indicate code number "0".
Programming your Zenith remote may allow you to use one remote
to work up to 4 different devices, if all modes are programmed.
Not all devices will work with your Zenith remote control.
Mode / Product Compatibility
TV
VCR
CATV
TVs VCRs
Cable Boxes,
DVDs Satellite Receivers
Mini glossary
PROGRAMMING
Procedure to set up remote to operate other equipment.
PRG
Programming mode key.
DEVICE CODE
Code to control infra-red remote controllable electronic devices: TVs, VCRs, Cable Boxes, etc.
P A G E 4 4
AUX
All products on pp 46 - 47
Indicator Light
1
PRG
CABLE
VCR
AUX
SURF
FLASHBK
CHANNEL
VOLUME
CHANNEL
1
2
4
5
7
8
-
0
MENU
RATIO
RECORD
PAUSE
TIMER
PLAY
REWIND
STOP
POWER
2
TV
MUTE
VOLUME
3
6
9
3
ENTER
VIDEO
SOURCE
2
F FWD
206-3767
Advertisement
Table of Contents
