Mode Sound Switch Setup - Zenith C32V23 Operating Manual & Warranty

Mode Sound Switch Setup

This feature is typically used to set up the remote to control the sound from an
external audio system, or cable box, without changing modes
Note: Check to make sure the remote operates the device you want to hear. If
not, see the remote programming page.
1 With a small blunt object, press and hold PRG until the LED
indicator light turns on (about 3 seconds), then release PRG.
2
Press the mode button of the device you want to hear:
CABLE, VCR, AUX, TV.
3
Press the Vol+ button, the LED will blink.
4
Press the button of the mode you want the volume to be con-
trolled by: CABLE, VCR, AUX, TV.
5 Press ENTER to save the code (The indicator light will flash 2
times and then turn off).
For example: If you want the VCR mode to control the volume of
the AUX mode (audio system), press VCR in Step 2 and press
AUX in Step 4. Then, when you press volume in VCR mode, the
device programmed for the AUX mode will respond.
Default Mode Volume Control Setups
Mode Sound controlling mode
TV TV
VCR TV
AUX AUX
CABLE CABLE
If you can't find the code for your amplifier, use the Auto Search
feature described on page 45.
Mini glossary
AMPLIFIER
CABLE BOX VOLUME
AUX
206-3767
(Controls TV volume.)
(Controls TV volume.)
(Controls AUX Volume.)
(Controls Cable Volume.)
Audio device which sends sound to speakers, like an Audio Tuner, Receiver, or Amplifier.
See Audio Tuners/Amp list on page 47.
Some cable boxes have volume controls.
Auxiliary equipment.
1
PRG
Indicator Light
CABLE
SURF
VOLUME
1
4
7
0
MENU
RATIO
RECORD PAUSE
REWIND
POWER
2/4
VCR AUX TV
FLASHBK MUTE
CHANNEL
3
VOLUME
CHANNEL
2 3
5 6
8 9
-
ENTER 5
VIDEO
SOURCE
TIMER
PLAY
F FWD
STOP
P A G E 4 3