Frame Assembly - UpDown Desk PRO Series Install Manual

05
Loosen (do not remove) the two shaft grub screws as shown of the wing/crank
assembly using Allen key 2. The hex shaft within is then able to move in/out.
Loosen the two bearing coupling screws as shown using Allen key 3. The shaft can then
slide back and forth within the bearing assembly. This will make for an easier installation
later.
NOTE: THE FRAME WILL BE ASSEMBLED UPSIDE-DOWN AT FIRST AS THIS IS THE SIMPLEST
METHOD.
06
Position the Leg (f) on the Wing/Crank Assembly (c) as shown (Figure A). The hex shaft
will slide into a hex seat within the leg.
NOTE: IT IS NOT NECESSARY TO DISASSEMBLE THE PRE-ASSEMBLED WING/CRANK.
Attach it onto the Leg (f) using two M8 x 10mm screws (Figure B).

FRAME ASSEMBLY

Allen Key #3
Figure A
Allen Key #2
Figure B
05